The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then publish the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 3: | Line 3: | ||
|description=3D Druck | |description=3D Druck | ||
|location=Electrolab | |location=Electrolab | ||
|resource category= | |resource category=Infrastruktur | ||
|image=Ultimaker.jpg | |image=Ultimaker.jpg | ||
|ownership=club | |ownership=club | ||
Line 12: | Line 12: | ||
|has label=No | |has label=No | ||
}} | }} | ||
Im FabLab steht ein Ultimaker 3 Extended, der zusätzlich mit Tür, Abdeckung und Abluftfilter ausgestattet ist. | Im FabLab steht ein Ultimaker 3 Extended, der zusätzlich mit Tür, Abdeckung und Abluftfilter ausgestattet ist. | ||
Line 20: | Line 21: | ||
== Benutzung == | == Benutzung == | ||
* Gedruckt wird direkt und ohne irgendwelche Zwischenkomponenten auf einer Glasplatte. Bitte '''kein''' Tape, Haarspray, Kleber o.ä. verwenden. Falls der Druck nicht gut haftet, hilft die Slicer-Einstellung "Enable Raft" meist weiter. | * Gedruckt wird direkt und ohne irgendwelche Zwischenkomponenten auf einer Glasplatte. Bitte '''kein''' Tape, Haarspray, Kleber o.ä. verwenden. Falls der Druck nicht gut haftet, hilft die Slicer-Einstellung "Enable Raft" meist weiter. | ||
* Beim Entfernen des Drucks bitte vorsichtig sein und keine scharfen Gegenstände verwenden. Das Druckbett ist aus Glas. | * Beim Entfernen des Drucks bitte vorsichtig sein und keine scharfen Gegenstände verwenden. Das Druckbett ist aus Glas. | ||
Line 32: | Line 32: | ||
--- | --- | ||
Stream: http://10.4.255.238:8080/?action=stream | |||