No edit summary |
(added a section describing the 3d printers) |
||
| Line 23: | Line 23: | ||
| no | | no | ||
| printing on media unsuitable for lasers | | printing on media unsuitable for lasers | ||
|} | |||
=== 3D === | |||
{| class=wikitable | |||
! Name | |||
! Description | |||
! Network? | |||
! Recommended use | |||
|- | |||
|[[Ultimaker 3 extended]] | |||
|Dual Extruder 3D Printer | |||
|yes | |||
|printing | |||
|- | |||
|[[Makerbot Replicator 2]] | |||
|Single Extruder 3D Printer | |||
|no | |||
|printing | |||
|- | |||
|[[Archiv:Orcabot]] | |||
|Single Extruder 3D Printer | |||
|no | |||
|admire | |||
|} | |} | ||
Revision as of 21:52, 25 March 2022
Table of printers
2D
| Name | Description | Network? | Recommended use |
|---|---|---|---|
| DCP-9055CDN | Color laser MFP (A4) | yes | printing & scanning |
| M276 | Color laser MFP (A4) | yes | printing & scanning |
| DeskJet | Color inkjet printer (A4) | no | printing on media unsuitable for lasers |
3D
| Name | Description | Network? | Recommended use |
|---|---|---|---|
| Ultimaker 3 extended | Dual Extruder 3D Printer | yes | printing |
| Makerbot Replicator 2 | Single Extruder 3D Printer | no | printing |
| Archiv:Orcabot | Single Extruder 3D Printer | no | admire |
Guidelines
- print on the smallest printer suitable
- before printing, turn printer on
- print single page to check your settings
- after printing, turn printer off
- donate money for your prints
- Paper empty? Check "Schrank 1" second from the right, third from the left.
Usage
All network printers should announce themselves via zeroconf/avahi/bonjour. Simply start the printer and wait for it to appear on your system. You need to plug in the non-network printers to your device and set them up as you would setup any other printer.